Журналы →  Eurasian mining →  2014 →  №1 →  Назад

EQUIPMENT AND MATERIALS
Название Hardening of a surface of teeths of the drive of spherical mills to methods superficial and plastic deformation (technique and experiment)
Автор Ibragimova Z. A., Povetkin V. V., Sushkova O. A., Tatybayev M. K.
Информация об авторе

Kazakh National Technical University named after K. I. Satpaev:

Ibragimova Z. A., Doctoral PhD, e-mail: zaure_1983_as@mail.ru

Povetkin V. V., Professor, Doctor of Engineering Sciences, e-mail: vv1940_povetkin@mail.ru

Sushkova O. A., Assistant Professor, Candidate of Engineering Sciences, e-mail: sol777ga@mail.ru

Tatybayev M. K., Assistant Professor, e-mail: mukhtar_t.k@mail.ru

Реферат

In article on the basis of the analysis of dynamic methods of finishing — strengthening processing of surfaces plastic deformation suggested a technique of hardening of a surface of cogwheels of the drive of spherical mills. Experimental works on superficial and plastic deformation of a surface of a shaft from steel of 35L are performed. Researches were carried out on the lathe with various modes of processing speed of rotation of preparation, effort of pressure of an roller and feed speed. During experimental works, parameters of surface hardness and roughness were registered. Surface hardness was measured up to the depth of 2 mm. On the basis of the experimental data, graphs with the above mentioned parameters are represented.

Ключевые слова Hardening, surface – plastic deformation, finishingstrengthening processing, cogwheel, tension, roller, roughness, hardness
Библиографический список

1 Babichev A. P., Motrenko P. D., etc. Finishing strengthening proces sing of details by a multicontact vibropercussion instrument. — Rostov-on-Don: DGTU publishing center, 2003, 192 p.
2 Available at: www.masters.donntu.edu.ua
3 Povetkin V. V., Sushkova O. A. Durability increase heavy-duty teeth gearings using surface plastic deformation methods. collections of materials from III international scientific conference: "Actual problems of mechanics and mechanical engineering". — Almaty, 2009. T.II. pp. 257–261.
4. Bases of scientific researches. By ed. V. I. Kru tov. — M.: The higher school, 1989.
5. Toyberg P. Estimation of accuracy of measurement results. — Energy publishing house, 1988, 88 p.
6 Kasatkin B. S., Kudrin A.B. etc. Experimental methods of deformations and tension research: Handbook. — Kiev: Naukova dumka, 1981, 584 p.
7. Nalimov V. V. Experiment theory. — M.: Science, 1971, 205 p.
8. Rumshinsky L. Z. Mathematical processing of experimental results. — M.: Science, 1971, 192 p.

Language of full-text английский
Полный текст статьи Получить
Назад