Journals →  Tsvetnye Metally →  2019 →  #9 →  Back

HEAVY NON-FERROUS METALS
ArticleName Cation exchange processing of buruktal oxidized nickel ore autoclave solutions
DOI 10.17580/tsm.2019.09.02
ArticleAuthor Saykova S. V., Panteleeva M. V., Saykova D. I.
ArticleAuthorData

Siberian Federal University, Krasnoyarsk, Russia:

S. V. Saykova, Professor at the Department of Physical and Inorganic Chemistry
D. I. Saykova, Undergraduate Student


Institute of Chemistry and Chemical Technology of the Siberian Branch of the Russian Academy of Sciences — a branch office of the Krasnoyarsk Science Centre of the Siberian Branch of the Russian Academy of Sciences, Krasnoyarsk, Russia:

M. V. Panteleeva, Research Fellow, e-mail: vp414@mail.ru

Abstract

This paper examines the new process of cation-exchange leaching applicable to acid autoclaving solutions of the oxidized nickel ores (ONOs) from the Buruktal deposit. The pulp resultant from neutralization (using CaO, CaCO3, Na2CO3) of pressure leaching solutions would be brought into contact with the ion-exchange resins KU-2 and KB-4, which in this case serve as both reagents and metal ion absorbents. The authors investigated how the process duration, the type of neutralizing agent, the type of ionite, the type of counter-ion and the amount of cationite influenced the selective leaching of nickel from the pulp. The optimum process conditions have been identified. It was established that when using cationites in the form of salts iron and aluminium remain in the deposit and fail to transfer in the ionite: the nickel-to-iron ratio increases from 1:20 in the initial solution to (2–3):1 in eluates. It was found that KB-4 has a higher nickel capacity than KU-2. At the same time the former is noticeably selective to calcium ions, that is why Na2CO3 would be a better neutralizing agent for the pressure leaching solutions obtained from the Buruktal ONOs. Cation-exchange leaching of pulps obtained through the effect of sodium carbonate, which relies on the use of the KB-4 cationite in the Na form, helps achieve a 98–99% recovery of nickel. The solutions resultant from sorbent elution contain almost no aluminium, and the concentration of iron in them is much lower than in the initial autoclave solution (the nickel-from-iron separation factor calculated by the authors is TNiFe = 75). Magnesium will be the main impurity metal (the nickel-from-magnesium separation factor reached is TNiMg = 33). However, magnesium can be separated during the nickel deposition stage.

keywords Oxidized nickel ores, cationite, cation-exchange leaching, ion exchange, Buruktal deposit, nickel, magnesium, iron, separation factor
References

1. Reznik I. D., Ermakov G. P., Shneerson Ya. M. Nickel. Moscow : Nauka i tekhnologii, 2001. Vol. 2. 468 p.
2. Naftal M. N., Dyachenko V. T., Serova N. V. The oxidized nickel ores are the prospective source of mineral raw materials for the increasing of nickel and cobalt production in OJSC “MMC “Norilsk nickel”. Tsvetnye Metally. 2012. No. 6. pp. 25–28.
3. Talovina I. V., Lieberwirth H., Alexandrova T. N., Heide G. Supergene oxide-silicate nickel deposits: mineral-geochemical composition and peculiarities of processing. Eurasian mining. 2017. No. 1. pp. 21–24.
4. Vitovskaya I. V., Bugelskiy Yu. Yu. Nickel-bearing residues of the Urals region. Moscow : Nauka, 1982. 190 p.
5. Elias M. Nickel laterite deposits – geological overview, resources and exploration. Giant Ore Deposits, Characteristics, Genesis and Exploration. CODES Special Publication 4. Hobart : University of Tasmania, 2002. pp. 205–220.
6. Zablotskaya Yu. V., Sadykhov G. B., Khasanov M. Sh., Smirnova V. B. Kinetics of sulphuric acid leaching of nickel from reduced limonite ore of the Buruktal deposit. Tsvetnye Metally. 2018. No. 12. pp. 36–41.
7. Tsemekhman L. Sh., Tsymbulov L. B. Modern problems of pyrometallurgical processing of oxidized nickel ores in Russia. Tsvetnye Metally. 2016. No. 11. pp. 38–44.
8. Stopi S., Friedrich B. Hydrometallurgical processing of nickel lateritic ores. Military technical courier. 2016. Vol. 64, No. 4. pp. 1033–1047.
9. Purwanto H., Shimada T., Takahashi R., Yagi J. Recovery of nickel from selectively reduced laterite ore by sulphuric acid leaching. Journal of the Iron and Steel Institute of Japan. 2003. Vol. 43, No. 2. pp. 181–186.
10. Chauhan S., Patel T. A Review on Solvent Extraction of Nikel. International Journal of Engineering Research and Technology. 2014. Vol. 3, No. 9. pp. 1315–1322.
11. Zolotov Yu. A., Kholkin A. I., Pashkov G. L., Kuzmin V. I., Sergeev V. V., Fleytlikh I. Yu. Hydrometallurgical processing of non-conventional raw materials containing rare and non-ferrous metals. Moscow : Forum, 2010. 180 p.
12. Pashkov G. L., Saikova S. V., Panteleeva M. V., Saikova D. I. Сation resin exchange leaching of oxidized nickel ores of the Ust-Porozhinskoye deposit. Tsvetnye Metally. 2018. No. 8. pp. 52–58.
13. Pashkov G. L., Saikova S. V., Panteleeva M. V. Reactive ion exchange processes of nonferrous metal leaching and dispersion material synthesis. Theoretical Foundations of Chemical Engineering. 2016. Vol. 50, No. 4. pp. 575–581.
14. De Villiers P. G. R., Van Deventer J. S. J. The use of ion-exchange resins for the recovery of valuable species from slurries of sparingly soluble solids. Minerals Engineering. 1997. Vol. 10, No. 9. pp. 929–945.
15. Mendes F. D. Resin-in-leach process to recover nickel and/or cobalt in ore leaching pulps. Patent 20090056500 US. Filed 31.07.2008.
16. Dreisinger D. B., Macdonald C. A., Shaw D. R. Process for metal seperation using resin-in-pulp or resin-in-solution processes. Patent 2009108993WO. Filed 26.02.2009.
17. Saykova S. V., Pashkov G. L., Panteleeva M. V. Reactive ion exchange processes of nonferrous metal leaching and dispersion material synthesis. Krasnoyarsk : SFU, 2018. 257 p.
18. Vulikh A. I. Ion exchange synthesis : Monograph. Moscow : Khimiya, 1973. 263 p.

Language of full-text russian
Full content Buy
Back