Journals →  Gornyi Zhurnal →  2021 →  #4 →  Back

CONSTRUCTION AND OPERATION OF UNDERGROUND OPENINGS
ArticleName Variable actual stiffness of guides in potash mine shafts
DOI 10.17580/gzh.2021.04.06
ArticleAuthor Pestrikova V. S., Yarushin A. D., Tarasov V. V., Shkuratskiy D. N.
ArticleAuthorData

VNII Galurgii, Perm, Russia:

V. S. Pestrikova, Senior Researcher, Candidate of Engineering Sciences, Pestrikova.Varvara@uralkalii.com
A. D. Yarushin, Engineer
V. V. Tarasov, Head of Laboratory of Mine Shaft Construction and Operation, Candidate of Engineering Sciences
D. N. Shkuratskiy, CEO, Candidate of Engineering Sciences

Abstract

The article addresses serviceability of reinforcement in vertical mine shafts. The mathematical framework is presented for the dynamic processes in the capsule–reinforcement system. The main causes of the dynamic loads in the capsule–reinforcement system are discussed. The importance of the processes in the capsule–reinforcement system during movement of hoists in vertical mine shafts is emphasized. It is asserted that solely computational methods are not enough to analyze processes inside the capsule–reinforcement systems in shafts. It is required to examine actual parameters of shaft reinforcement, in particular, the actual stiffness of shaft guides. The actual measurement procedure of guide stiffness in potash mine shafts is presented. The full-scale tests data are set out in connection with the actual step of reinforcement in shafts. The actual and calculated values of stiffness of shaft guides are compared. Based on the obtained results, the variable stiffness coefficient is derived for the shaft guide stiffness for a few alternative of reinforcement step. Considering the described research findings and the many years-long experience gained in operation of mine shafts, the authors have drawn a conclusion on the necessity to take into account the factor of variable stiffness of guides in shaft design and construction in potash mines in the Upper Kama Potash–Magnesium Salt Deposit, especially in case when the shaft reinforcement step exceeds the project design standards.

keywords Mine shaft, hoisting capsule, dynamic load, guides, stiffness characteristics, bunton, reinforcement serviceability
References

1. Baklashov I. V. Reinforcement design, engineering and installation in mine shafts. Moscow : Nedra, 1973. 248 p.
2. Zalesov O. A. Reinforcement of vertical mine shafts and the analysis on electronic simulators. Moscow : Nedra, 1966. 220 p.
3. Ilin S. R., Trifanov G. D. Run-time diagnostics of hoist capsule–reinforcement systems in vertical mine shafts. Gornoe oborudovanie i elektromekhanika. 2009. No. 8. pp. 29–34.
4. Ilin S. R., Trifanov G. D., Vorobel S. V. Integrated experimental research into dynamics of capsules in hoisting mine shafts. Gornoe oborudovanie i elektromekhanika. 2011. No. 5. pp. 30–35.
5. Prokopov A. Yu., Bogomazov A. A. Basakevich S. V. Calculation of additional vertical load on stiff reinforcement guides in case of their deviation from the design position. Mineral Mining, Mine and Underground Construction : Science and Technology. Collection of Scientific Papers. Novocherkassk : Izdatelstvo Yuzhno-Rossiyskogo gosudarstvennogo tekhnicheskogo universiteta (Novocherkasskiy politekhnicheskiy institut), 2006. pp. 234–242.

6. Pestrikova V. S. Algorithm for calculating the durability of rigid reinforcements of shaft operating under the conditions of Verkhnekamsky deposits of potassium salts. Izvestiya Tulskogo gosudarstvennogo universiteta. Nauki o Zemle. 2019. No. 4. pp. 332–339.
7. Pestrikova V. S., Tarasov V. V. Survey on distribution of corrosion wear rate of rigid equipment elements by the example of the mine shafts of Solikamsk potash mine № 3 of Verkhnekamskoye potash salt deposit. GIAB. 2016. No. 8. pp. 326–332.
8. Olkhovikov Yu. P. Support of permanent workings of potassium and salt deposits. Moscow : Nedra, 1984. 238 p.
9. Olkhovikov Yu. P., Gomenyuk V. I., Yarushin A. D. Recommendations on shaft reinforcement in potash mines. Berezniki, 1974. 42 p.
10. Voloshin A. I., Rubel A. A., Rubel A. V. Equipment for vertical mine shafts and methods for its improvement. Geo-Technical Mechanics : Collected Scientific Papers. Dnepropetrovsk, 2016. Vol. 126. pp. 137–145.
11. Bulat A. F., Slashchev I. N., Ikonnikova N. A. Principles for the development of remote control systems of the mine safety. Geo-Technical Mechanics : Collected Scientific Papers. Dnepropetrovsk, 2017. Vol. 137. pp. 3–17.
12. Gomenyuk V. I. Dynamic loads in mine shafts with cast-iron tubing support : A case-study of the Upper Kama Potash Deposit. Dissertation … of Candidate of Engineering Sciences. Perm, 1974. 211 p.
13. Ilin S. R., Radchenko V. K., Adorskaya L. G. Risk-forming processes in the work of mine lifting units. Geo-Technical Mechanics : Collected Scientific Papers. Dnepropetrovsk, 2017. Vol. 134. pp. 22–35.
14. Rubel A. A. Study of existing structures of floors of vertical shaft equipment and development of schemes for floors with the rope-profiled guides. Geo-Technical Mechanics : Collected Scientific Papers. Dnepropetrovsk, 2017. Vol. 134. pp. 211–227.
15. Ozturk H., Guler E. A methodology for lining design of circular mine shafts in different rock masses. International Journal of Mining Science and Technology. 2016. Vol. 26, Iss. 5. pp. 761–768.
16. Yagodkin F., Pleshko M., Prokopov A. Perspective Schemes Equipment Ultra-deep Shafts. Procedia Engineering. 2017. Vol. 206. pp. 293–298.
17. Muhamedin Hetemi, Rafet Zeqiri. Concept Paper on Shaft Sinking of the Mine “Trepca” in Stanterg New Horizons XIth to XIIIth. Journal of International Environmental Application and Science. 2016. Vol. 11, Iss. 1. pp. 65–71.
18. Brady B. H. G., Brown E. T. Rock Mechanics For underground mining. 3rd ed. Dordrecht : Springer, 2006. 628 p.
19. Konicek P., Schreiber J. Heavy rockbursts d ue to longwall mining near protective pillars: A case study. International Journal of Mining Science and Technology. 2018. Vol. 28, Iss. 5. pp. 799–805.

Full content Variable actual stiffness of guides in potash mine shafts
Back