Management Company Polyus, Moscow, Russia:

R. A. Rakhmanov, Senior Drill and Blast Manager, Candidate of Engineering Sciences, RakhmanovRA@polyus.com
V. N. Lushnikov, Chief Geomechanical Engineer

Polyus Proekt, Krasnoyarsk, Russia:

I. A. Alenichev, Chief Specialist, Candidate of Engineering Sciences

It is commonly known that rock fragmentation by blasting is the most economically efficient method to prepare large volumes of rock mass to excavation and handling. The drilling and blasting technology accepted by a mine governs both rock fragmentation quality and mining safety connected with slope stability. Therefore, optimization of drilling and blasting is an objective calling for the effective blast design and control. This article presents the main principles and methods of moderate blasting implemented at Polyus company towards minimization of impact on pit walls and benches. The main point is stagewise reduction of the dynamic effect exerted by blasting on rock mass when approaching the ultimate pit limits. Polyus company initiated the far and wide review and introduction of the best international practices for improvement of blasting operations near the ultimate pit limits. The article describes the activities undertaken within implementation of projects on drilling and blasting technology justification and improvement to enhance stability of pit walls and, as a consequence, to reduce geotechnical hazards. As a complimentary measure to abate seismic effect of explosions on adjacent rock mass, the nonelectric blasting is replaced by electronic blast initiation systems with more accurate delay intervals, which almost nullifies probability of simultaneous ignition of two or more charges and ensures, thereby, the acceptable and seismically safe modes of blasting of large rock blocks. Furthermore, the introduction of the electronic blasting cardinally changes the approach to blasting order and sequence per intervals in blast holes depending on the current task within a block to be blasted.

1. Lushnikov V. N. Fracturing at ore body–rock interface as a result of blasting. Current Condition and Prospects of Drilling-and-Blasting in Polyus Territory : Forum of Drilling-and-Blasting. Krasnoyarsk, 2017.
2. Fokin V. A. Methodic aspects of analyzing technological information during drilling-and-blasting operations in open-pits. Apatity : KNTs RAN, 2015. 133 p.
3. Bondarenko I. F., Zharikov S. N., Syryanov I. V., Shemenev V. G. Drilling and blasting in open pit kimberlite mines in Yakutia. Ekaterinburg : IGD UrO RAN, 2017. 172 p.
4. Belin V. A., Kholodilov A. N., Gospodarikov A. P. Methodical principles of prediction of seismic effect due to large-scale blasting. Gornyi Zhurnal. 2017. No. 2. pp. 66–69. DOI: 10.17580/gzh.2017.02.12
5. Lyashenko V. I., Golik V. I., Komashenko V. I., Kislyi P. A., Rakhmanov, R. А. Increase of seismic safety of underground mining of rock deposits on the basis of application of new means of initiation of explosions of explosive charges. Vzryvnoe delo. 2019. No. 122/79. pp. 154–179.
6. Silva J., Worsey T., Lusk B. Practical assessment of rock damage due to blasting. International Journal of Mining Science and Technology. 2019. Vol. 29, Iss. 3. pp. 379–385.
7. Jun Han, Hongwei Zhang, Bin Liang, Hai Rong, Tianwei Lan et al. Influence of Large Syncline on In Situ Stress Field: A Case Study of the Kaiping Coalfield, China. Rock Mechanics and Rock Engineering. 2016. Vol. 49, Iss. 11. pp. 4423–4440.
8. Kozyrev S. A., Alenichev I. A., Kamyanskiy V. N., Sokolov A. V. Features of seismic presplit ting blasting action on the out-contour rock and methods of its reduction under the conditions of "Iron" open pit mining on the Kovdorsky Processing Plant. Vzryvnoe delo. 2017. No. 118/75. pp. 212–226.
9. Dindarloo S. R., Askarnejad N.-A., Ataei M. Design of controlled blasting (pre-splitting) in Golegohar iron ore mine, Iran. Transactions of the Institutions of Mining and Metallurgy: Section A: Mining Technology. 2015. Vol. 124, No. 1. pp. 64–68.
10. Silva J., Worsey T., Lusk B. P ractical assessment of rock damage due to blasting. International Journal of Mining Science and Technology. 2019. Vol. 29, Iss. 3. pp. 379–385.
11. Trofimov A. V., Vilchinskaya O. V., Breus K. E., Amosov I. V. Comprehensive study of physical and mechanical properties of rocks by modern methods and means for optimisation of mining and metallurgical operations. Tsvetnye Metally. 2014. No. 9. pp. 16–23.
12. McKenzie C. K. Blasting near open pit walls. Proceedings of the First Asia Pacific Slope Stability in Mining Conference. Brisbane, 2016. pp. 83–94.
13. Xiang Xia, Haibo Li, Jingtao Niu, Jianchun Li, Yaqun Liu. Expe rimental study on amplitude change of blast vibrations through steps and ditches. International Journal of Rock Mechanics and Mining Sciences. 2014. Vol. 71. pp. 77–82.
14. Shrey Arora, Kaushik Dey. Estimation of near-field peak particle velocity: A mathematical model. Journal of Geology and Mining Research. 2010. Vol. 2(4). pp. 68–73.
15. Alenichev I. A. Rock mass response to dynamic effect of blasting in the area of open pit mine. GIAB. 2018. No. 7. pp. 189–195.
16. Alenichev I. A., Rakhmanov R. A., Shubin I. L. Assessment of near-field blast effect toward optimized drilling-and-blasting in pit wall rock mass. GIAB. 2020. No. 4. pp. 85–95.