Journals →  Obogashchenie Rud →  2016 →  #6 →  Back

ENVIRONMENT PROTECTION TECHNOLOGY
ArticleName Estimation of efficiency of hydrotransport pipelines polyurethane coating application in comparison with steel pipelines
DOI 10.17580/or.2016.06.09
ArticleAuthor Aleksandrov V. I., Kibirev V. I.
ArticleAuthorData

St. Petersburg Mining University (Russia):

Aleksandrov V. I., Doctor of Engineering Sciences, Professor, Head of Chair, victalex@mail.ru

 

Mekhanobr Engineering CJSC (Russia):
Kibirev V. I., Ph. D. in Engineering Sciences, Head of Department

Abstract

The paper presents analytical calculations of specific pressure loss in hydraulic transport of the Kachkanarsky MCC iron ore processing tailings slurry. The calculations are based on the results of the experimental studies on specific pressure loss dependence upon hydraulic roughness of pipelines internal surface, lined with polyurethane coating. The experiments proved that hydraulic roughness of polyurethane coating is by the factor of four smaller, than that of steel pipelines, resulting in decrease of hydraulic resistance coefficients entered into calculating formula of specific pressure loss — the Darcy—Weisbach formula. Relative and equivalent roughness coefficients are calculated for pipelines with polyurethane coating and without it. Comparative calculations show that hydrotransport pipelines polyurethane coating application is conductive to specific energy consumption decrease in hydraulic transport of the Kachkanarsky MCC iron ore processing tailings slurry by the factor of 1.5. The experiments were performed on a laboratory hydraulic test rig with a view to estimate character and rate of physical roughness change in pipe samples with polyurethane coating. The experiments showed that following 484 hours of operation, roughness changed in all pipe samples inappreciably. As a result of processing of the experimental data by the mathematical statistics methods, an empirical formula was obtained for calculation of operating roughness of polyurethane coating surface, depending on pipeline operating duration with iron ore processing tailings slurry.

keywords Roughness, hydraulic resistance coefficient, equivalent roughness, particle-size distribution, slurry, specific pressure loss
References

1. Alexandrov V. I., Vasylieva M. A. The rheological properties of high concentration slurry at pipeline transportation on example of copper-nickel ore tailings. Reports of the XXIII Int. Sci. Symp. «Miner’s week — 2015», 2015, pp. 452–460.
2. Aleksandrov V. I., Avksentye S. Yu., Gorelkin I. M. Energy inputs minimization in slurry hydraulic transportation. Obogashchenie Rud = Mineral Processing, 2012, No. 3, pp. 39–42.
3. Darcy H. Recherches expérimentales relatives au mouvement de l'eau dans les tuyaux. Paris, Malet-Bachelier, 1857.
4. Heywood, N., Richardson J. Head loss reduction by gas injection for highly shear-thinning suspensions in horizontal pipe flow. Proc. Hydrotransport 5, BHRA Fluid Engineering, 1978, Paper C1, pp. 146–152.
5. Heywood N., Alderman J. Developments in slurry pipeline technologies. Chem. Eng. Prog., 2003, 4, pp. 100–107.
6. Kumar U., Singh S. N., Seshadri V. Bi-modal slurry pressure drop characteristics at high concentration in straight horizontal pipes. Int. J. of Engineering and Technical Research (IJETR), 2015, Vol. 3, Iss. 4, pp. 394–397.
7. Schmitt D. J. Experimental investigation of surface roughness microstructures and their effects on pressure drop characteristics in rectangular minichannels. M. S. thesis. Rochester Institute of Technology, 2004.
8. ISO 868—85. Plastics and ebonite. Determination of indentation hardness by means of a duromater (Shore hardness). Moscow, Committee for Standardization and Metrology of the USSR.
9. Portable Surface Roughness Tester SURFTEST SJ-210 Series. Mitutoyo America Corporation. URL: http://www.mitutoyo.com/Images/003/316/2140_SJ-210.pdf, date of the application: 1.12.2016.
10. Nikuradse J. Gesetzmässigkeiten der turbulenten Strömung in glatten Rohren. Ver. Deut. Ing. Forschungsheft, 1932, No. 356.
11. Nikuradse J. Stromungsgesetze in rauhen Rohren. Ver. Deut. Ing. Forschungsheft, 1933, No. 361.
12. Yagi T., Okude T., Miyazaki S., Koreishi A. An analysis of the hydraulic transport of solids in horizontal pipes. Report of the Port & Harbour Research Institute (Japan), 1972, Vol. 11, No. 3.
13. Dobromyslov A. I. Tablitsy dlya gidravlicheskikh raschetov truboprovodov iz polimernykh materialov (Tables for the hydraulic calculation of pipelines made of polymer materials). Moscow, VNIIVP, 2004, 209 pp.

Language of full-text russian
Full content Buy
Back