Journals →  Tsvetnye Metally →  2018 →  #2 →  Back

LIGHT METALS AND CARBON MATERIALS
ArticleName Spatial particle distribution during Stokes sedimentation of alumina in high temperature concentrated suspension-electrolyte for aluminium production
DOI 10.17580/tsm.2018.02.05
ArticleAuthor Yasinskiy A. S., Polyakov P. V., Yushkova O. V., Sigov V. A.
ArticleAuthorData

School of non-ferrous metals and material science, Siberian federal university, Krasnoyarsk, Russia:
A. S. Yasinskiy, Senior Lecturer of a Chair of Metallurgy of Non-Ferrous Metals, phone: +7-983-169-78-09
P. V. Polyakov, Professor, Consultant of a Chair of Metallurgy of Non-Ferrous Metals
O. V. Yushkova, Head of Laboratory of V. S. Biront Chair of Metal Science and Thermal Processing of Metals
V. A. Sigov, Master’s Degree Student of a Chair of Non-ferrous Metals Metallurgy

Abstract

Our paper researches the behavior of high-temperature electrolyte suspensions in liquid metals production (in particular aluminium) and demonstrates new experimental data that explain some features of sedimentation in such systems. The experiments were carried out at 700 оC on the KF – AlF3 – Al2O3 suspension system. The local concentration of particles is determined as a function of the vertical coordinate and time with different volume fraction of particles in the suspension (φ). The transition of the first type of sedimentation to the third type for a system with the volume fraction φ = 0.24 was identified. An uncharacteristic type of sedimentation was observed when φ = 0.28. It is expressed in a gradual increase of φ with the vertical coordinate (z) without shocks, inherent for the transition from the settlement zone to the sediment. When φ = 0.32, the z – dependence indicates a hindered sedimentation, the value of  is close to the maximum packing fraction (φm), which corresponds to an infinitely large suspension viscosity. Dependence of the average particle size on z for systems with different compositions was investigated on micrographs of solidified samples. Sedimentation at low Reynolds numbers is significantly hindered in the part of the disperse system that is located near the wall that is bounding it. With a decrease of an average particle size and polydispersity, φm decreased as well, which is accordance with literature data. It was established that φm strongly depends on the presence of a rigid wall. Based on the obtained results, we can assert that the decrease in the anode — cathode distance (ACD) is a very important direction in development of suspension electrolysis technology with vertical electrodes, and should be set in the 5 < ACD < 15 mm range in order to drop energy consumption. The solid phase volume fraction in the KF – AlF3 – Al2O3 system can then be set from 0.28 to 0.32, depending on the established ACD. Under such conditions, one should expect suppressed sedimentation and uniform current distribution.
Our investigation was carried out with the financial support of the Russian Foundation for Basic Research, the Government of Krasnoyarsk Region, Krasnoyarsk regional funds for the support of scientific and scientific and technical activities within the scientific project No. 16-43-240781.

keywords Aluminium, alumina, suspension, settlement, sedimentation, cryolite melt, low temperature electrolysis, particle distribution, non-newtonian fluids, Stokes regime
References

1. Polyakov P. V., Klyuchantsev A. B., Yasinskiy A. S., Popov Y. N. Conception of “Dream Cell” in aluminium electrolysis. Light Metals. 2016. pp. 283–288.
2. Yasinskiy A. S., Vlasov A. A., Polyakov P. V., Solopov I. V. Impact of alumina partial density on the process conditions of aluminium reduction from cryolitealumina slurry parameters. Tsvetnye Metally. 2016. No. 12. pp. 33–38.
3. Yasinskiy A. S., Polyakov P. V., Klyuchantsev A. B. Motion dynamics of anodic gas in the cryolite melt – alumina high temperature slurry. Russian Journal of Non-Ferrous Metals. 2017. Vol. 58, No. 2. pp. 109–113.
4. Kulik N. P., Stepanov V. P., Antonov B. D., Dokashenko S. I. Sedimentation of magnesium oxide suspension in the equimolar melt KCl – NaCl. Doklady Akademii nauk. 1995. Vol. 343, No. 1. pp. 65–67.
5. Moiseev G. K. About some rheological properties of high-concentrated suspensions made of magnesium oxide powders and melt of alkaline metal carbonates. Trudy instituta elektrokhimii. 1970. No. 14. pp. 112–118.
6. Azema N. Sedimentation behaviour study by three optical methods — granulometric and electrophoresis measurements, dispersion optical analyser. Powder Technology. 2006. Vol. 165. p. 133–139.
7. Chen J. F., Luo Y., Xu J. H., Chen Q. M., Guo J. Visualization study on sedimentation of micron iron oxide particles. Journal of Colloid and Interface Science. 2006. Vol. 301. pp. 549–553.
8. Urev N. B. Fluidity of suspensions and powders. Moscow : Khimiya, 1992. 256 p.
9. Vesaratchanon J. S., Nikolov A., Wasan D. T. Sedimentation of concentrated monodisperse colloidal suspensions: Role of collective particle interaction forces. Journal of Colloid and Interface Science. 2008. Vol. 322. pp. 180–189.
10. Shewan H. M., Stokes J. R. Analytically predicting the viscosity of hard sphere suspensions from the particle size distribution. Journal of Non-Newtonian Fluid Mechanics. 2015. Vol. 222. pp. 72–81.
11. Moon J. Y., Dai S., Chang L., Lee J. S., Tanner R. I. The effect of sphere roughness on the rheology of concentrated suspensions. Journal of Non-Newtonian Fluid Mechanics. 2015. Vol. 223. pp. 223–239.
12. Hernando L., Omari A., Reungoat D. Experimental study of sedimentation of concentrated mono-disperse suspensions: Determination of sedimentation modes. Powder Technology. 2014. Vol. 258. pp. 265–271.
13. Hernando L., Omari A., Reungoat D. Experimental investigation of batch sedimentation of concentrated bidisperse suspensions. Powder Technology. 2015. Vol. 275. pp. 273–279.
14. Isaeva L. A., Polyakov P. V. Alumina in electrolysis production of aluminium. Krasnoturinsk : Izdatelskiy dom OAO “BAZ”, 2000. 199 p.
15. Fernandez R., Ostvold T. Surface tension and density of molten fluorides and fluoride mixtures containing cryolite. Acta Chemica Scandinavica. 1989. Vol. 42. pp. 151–164.

Language of full-text russian
Full content Buy
Back