Journals →  Gornyi Zhurnal →  2021 →  #4 →  Back

GEOLOGY, PHYSICS AND MECHANICS OF ROCKS
ArticleName Technology and specificity of surface seismic in the Upper Kama Potash Salt Deposit
DOI 10.17580/gzh.2021.04.01
ArticleAuthor Tsarev R. I., Zhukov A. A., Prigara A. M., Shkuratskiy D. N.
ArticleAuthorData

VNII Galurgii, Perm, Russia:

R. I. Tsarev, Senior Researcher, roman.tsarev@uralkali.com
A. A. Zhukov, Head of Laboratory of Geophysics, Candidate of Engineering Sciences
A. M. Prigara, Leading Researcher, Candidate of Engineering Sciences
D. N. Shkuratskiy, CEO, Candidate of Engineering Sciences

Abstract

Exploration surveys at the Upper Kama Potash Salt Deposit widely use the surface seismic method by the common reflection point at depth. Based on the implemented research, a technology is developed for shallow seismic using an explosion source of elastic vibrations for the purposes of geological exploration. The research involved the comparative analysis of the main elastic wave sources used in the shallow seismic. It is highlighted that it is important to consider carefully the near-surface section structure and the surface relief. The accuracy of the velocity analysis procedure in the high-velocity section of salt strata is analyzed. The specificity of acquisition in the shallow seismic with an explosion source is discussed. The actual test data show a considerable increment in the energy of reflections from the roof and floor of the salt strata, which, in the absence of a priori geological information and geophysical logging data (acoustic logging and vertical seismic profiling), affects the velocity analysis precision and, as a consequence, the accuracy of reflection identification at depth. It is found that the explosion source has a much higher signal/noise ratio as against a pulse cartridge, which greatly improves neutrality of interpretation results. The use of a pulse cartridge in the surveys in the depth interval of 200–400 m is only justified when the surface conditions are perfect and the low velocity layer is not thick.

keywords Upper Kama Potash Salt Deposit, surface seismic, seismic reflection method, pulse cartridge, explosion energy, low velocity layer, acoustic impedance
References

1. Ampilov Yu. P. From seismic interpretation to modeling and assessment of oil and gas reservoirs. Moscow : Spektr, 2008. 383 p.
2. Kashnikov Yu. A., Ermashov A. O., Efimov A. A. Geological and geomechanical model of the Verkhnekamsk potash deposit site. Journal of Mining Institute. 2019. Vol. 237. pp. 259–267.
3. Kamnev E. N., Morozov V. N., Tatarinov V. N., Kaftan V. I. Geodynamic aspects of investigations in underground research laboratory (Nizhnekansk Massif). Eurasian Mining. 2018. No. 2. pp. 11–14. DOI: 10.17580/em.2018.02.03
4. Spasskiy B. A. Accounting for near-surface section in seismic exploration. Irkutsk : Izdatelstvo IGU, 1990. 181 p.
5. Monk D. J. Survey Design and Seismic Acquisition for Land, Marine, and In-between in Light of New Technology and Techniques : 2020 Distinguished Instructor Short Course. Distinguished Instructor Series, No. 23. Tulsa : Society of Exploration Geophysicists, 2020. 214 p.
6. Qing-Zhong Li. High-Resolution Seismic Exploration. Tulsa : Society of Exploration Geophysicists, 2017. 320 p.

7. Tsarev R. I. The rationale for selecting the geological environment model in the seismic CDP survey forward solution on the Verkhnekamskoye salt deposit. Geofizika. 2018. No. 5. pp. 18–23.
8. Jackson M. P. A., Hudec M. R. Salt Tectonics. Principles and Practice. Cambridge : Cambridge University Press, 2017. 498 p.
9. Golubev B. M. Structure of salt strata in the Upper Kama deposit : thesis of Dissertation … of Candidate of Geologo-Mineralogical Sciences. Perm, 1972. 31 p.
10. Kudryashov A. I. Verkhnekamskoe salt deposit. 2nd enlarged edition. Moscow : Epsilon Plus, 2013. 368 p.
11. Ivanov A. A., Voronova M. L. Upper Kama Potash Salt Deposit: Stratigraphy, mineralogy and petrography, tectonics, genesis. Transactions of the All-Union Scientific Research Geological Institute. New Series. Leningrad : Nedra, 1975. Vol. 232. 217 p.
12. Sanfirov I. A. Mine objectives of seismic exploration by the common depth point. Yekaterinburg : Izdatelstvo UrO RAN, 1996. 165 p.
13. Sanfirov I. A., Yaroslavtsev A. G., Akhmatov A. E. et al. Pulsed powder elastic wave source. Patent RF, No. 2439620. Applied: 15.06.2010. Published: 10.01.2012. Bulletin No. 1.
14. Boganik G. N., Gurvich I. I. Seismic exploration. Tver : AIS, 2006. 744 p.
15. Cherepovskiy A. V. Next technological level of surface seismic. 2nd revised edition. Moscow : EAGE Geomodel LLC, 2017. 252 p.
16. Buryak S. V., Vakulenko S. A. Reliability of observed reflection boundaries in stacked sections of engineering method of the common reflection point at depth. The 8th EAGE International Scientific and Practical Conference and Exhibition on Engineering and Mining Geophysics 2012. Gelendzhik, 2012. DOI: 10.3997/2214-4609.20146038
17. Dondurur D. Acquisition and Processing of Marine Seismic Data. Amsterdam : Elsevier, 2018. 606 p.
18. Kharitonov T. V., Oborina E. V., Popov A. G. et al. Generation of composite geological and hydrogeological maps of the Upper Kama Potash Salt Deposit, Scale 1:100 000. Perm, 2002. Book 1.
19. Zhukov A. A., Prigara A. M., Tsarev R. I., Pushkareva I. Yu. Method of mine seismic survey for studying geological structure features of Verkhnekamskoye salt deposit. GIAB. 2019. No. 4. pp. 121–136.
20. Tsarev R. I. Capacities of S-wave exploration in mines. Engineering and Mining Geophysics 2019 : Proceedings of the 15th Conference and Exhibition. Gelendzhik, 2019. Vol. 2019. DOI: 10.3997/2214-4609.201901765

Full content Technology and specificity of surface seismic in the Upper Kama Potash Salt Deposit
Back