Journals →  Gornyi Zhurnal →  2022 →  #2 →  Back

MINE SURVEYING
ArticleName Instrumental monitoring of ore stockpile stability in heap leaching area
DOI 10.17580/gzh.2022.02.03
ArticleAuthor Nizametdinov F. K., Nizametdinov N. F., Nizametdinov R. F., Oralbai A. O.
ArticleAuthorData

Karaganda State Technical University, Karaganda, Kazakhstan:

F. K. Nizametdinov, Professor, Doctor of Engineering Sciences, niz36@mail.ru
N. F. Nizametdinov, Associate Professor, Candidate of Engineering Sciences
R. F. Nizametdinov, Associate Professor, Candidate of Engineering Sciences
A. O. Oralbai, Doctoral Student

Abstract

The current trend in open pit mineral mining is the increased recovery of nonferrous metals by heap leaching of oxidized ore on the shallow horizons. This article presents the case-study of Aktogai open pit copper mine having the project depth to 500 m. To implement heap leaching, ore stockpiling is carried out on ground surface, on a weak clayey and slightly sloped bottom, by layers 12–15 m high. The proposed instrumental monitoring procedure for the stockpiles in the heap leaching area uses a pillar of improved design, arranged below the depth of freezing and outside the potential displacement zone for the installation of an electronic tacheometer and check points with optical reflectors, stiffly bound with the ore stockpile using concrete. The high-precision geodetic measurements allow surveying in a single vertical plane using the check points arranged in the profile cross-section in the area of heap leaching. The values of displacements are determined both in vertical and horizontal planes of the ore stockpile. It is found that the stockpile body undergoes continuous compaction due to the permanent addition of new layers. The deformation mechanism of the stockpile is governed by the continuous stress, which is proved by the displacement values of the check points. In the middle of the stockpile, continuous compaction takes place at a rate up to 7.07 mm/day, while at the slope bottom of the stockpile, slight horizontal displacements toward the support pillar are observed at a rate to 4.90 mm/day. According to the current guidance procedures, such rates of displacement are not hazardous for the production process, as the threshold is 10 mm/day, but continuous instrumental monitoring of the ore stockpile stability in the heap leaching areas is required to reveal maximum allowable displacements and prevent landsliding.

keywords Check point, pillar, electronic tacheometer, optical reflector, instrumental measurement procedure, measurement precision assessment, displacement data analysis
References

1. Guidance on observation over deformation of pitwall, benches and dump slopes at surface mines and the slope stability procedure. Kazakhstan, 2008.
2. Golser J., Steiner W. International and European standards for geotechnical monitoring and instrumentation. Geomechanics and Tunnelling. 2021. Vol. 14, Iss. 1. pp. 63–77.
3. Hormes A., Adams M., Amabile A. S., Blauensteiner F., Demmler C. et al. Innovative methods to monitor rock and mountain slope deformation. Geomechanik und Tunnelbau. 2020. Vol. 13, Iss. 1. pp. 88–102.
4. Souley M., Renaud V., Al Heib M., Bouffier C., Lahaie F. et al. Numerical investigation of the development of the excavation damaged zone around a deep polymetallic ore mine. International Journal of Rock Mechanics and Mining Sciences. 2018. Vol. 106. pp. 165–175.
5. Qinghua Lei, Ke Gao. A numerical study of stress variability in heterogeneous fractured rocks. International Journal of Rock Mechanics and Mining Sciences. 2019. Vol. 113. pp. 121–133.
6. Shpakov P. S., Ozhigin S. G., Dolgonosov V. N., Ozhigina S. B. Stability control of internal dumps. Trudy universiteta. 2020. No. 2(79). pp. 42–46.
7. Besimbaeva O. G., Ustavich G. A., Oleynikova E. A. Undermined ground surface deformation monitoring. Nauki o Zemle. 2017. No. 4. pp. 190–203.
8. Nizametdinov N. F., Baryshnikov V. D., Nizametdinov R. F., Igemberlina M. B., Stankova H. et al. Analysis of Ground Surface Displacements under the Influence of Repeated Mining Activities in the Zhezkazgan Area. Journal of Mining Science. 2021. Vol. 57, Iss. 2. pp. 184–189.
9. Lianhuan Wei, Yun Zhang, Zhanguo Zhao, Xiaoyu Zhong, Shanjun Liu et al. Analysis of Mining Waste Dump Site Stability Based on Multiple Remote Sensing Technologies. Remote Sensing. 2018. Vol. 10, Iss. 12. 2025. DOI: 10.3390/rs10122025
10. Igemberlina M. B., Nizametdinov R. F., Estaeva A. R., Satbergenova A. K. Application of advanced technologies in geodetic monitoring of ground surface movements. Gornyi zhurnal Kazakhstana. 2020. No. 3. pp. 19–24.
11. Gorokhov D. A., Ozhigin D. S., Ozhigina S. B., Dorosh N. A., Kulygin D. A. et al. System of geomonitoring of the technogenic objects. Interexpo Geo-Sibir. 2017. Vol. 1, No. 1. pp. 135–139.
12. Sitnikova E. V., Khmyrova E. N., Ozhigin D. S. Methodology of instrumental control of stability of quarry slopes using GNSS technologies. Interexpo Geo-Sibir. 2020. Vol. 1, No. 1. pp. 161–168.
13. Rybin V. V., Konstantinov K. N., Rozanov I. Yu. A multilevel approach to pitwall stability monitoring. Journal of Mining Science. 2021. No. 5. pp. 106–113.
14. Usanova A. V., Usanov S. V. Monitoring of Ground Surface Displacement under Mining of the Sokolovo-Sarbai Deposit by the Radar Interferometry Method. Journal of Mining Science. 2018. Vol. 54, Iss. 4. pp. 556–560.

Language of full-text russian
Full content Buy
Back